HP (Hewlett-Packard) hn200w Manuel D’Utilisation
wireless gateway
8
reset button
To refresh Gateway connections and attempt to fix routing problems, very briefly
depress the Reset button with a paper clip.
depress the Reset button with a paper clip.
If you have exhausted all troubleshooting options (see the Troubleshooting section of
this user’s guide) and continue to experience serious routing problems, depress the
Reset button for about five seconds to clear all of the Gateway data and restore
the factory default settings.
this user’s guide) and continue to experience serious routing problems, depress the
Reset button for about five seconds to clear all of the Gateway data and restore
the factory default settings.
If the Gateway locks up, unplug the Power Adapter from the Gateway’s Power Port
for 3 to 5 seconds (but not longer) and then plug it back in. Leaving the power off
for too long could result in the loss of network connections.
for 3 to 5 seconds (but not longer) and then plug it back in. Leaving the power off
for too long could result in the loss of network connections.
Uplink Port
You can connect a cable from another
switch, router, or hub to the Uplink port to
add it to your network. Since the Uplink
port shares wiring with LAN Port 4, port 4
will be disabled if a cable is plugged into
the Uplink port (and vice versa).
switch, router, or hub to the Uplink port to
add it to your network. Since the Uplink
port shares wiring with LAN Port 4, port 4
will be disabled if a cable is plugged into
the Uplink port (and vice versa).
Power
You will connect the included AC Power
Adapter to the Power port.
Adapter to the Power port.
Antenna Jacks
Connect the included antennas to the
antenna jacks.
antenna jacks.
Warning:
Resetting the Gateway may create conflicts between your PC’s actual IP
addresses and what the Gateway expects them to be. You may be forced to restart the
entire system.
entire system.