Manualsbrain.com
  1. Manuels
  2. Marques
  3. Proxim
  4. AP-2000
  5. Manuel D’Utilisation

Proxim AP-2000 Manuel D’Utilisation

Télécharger
Page de 244
172
Using the Command Line Interface (CLI)
Alarms Parameters
SNMP Table Host Table Parameters
When creating table entries, you may either specifying the argument name followed by argument value. CLI applies 
default values to the omitted arguments. Due to the nature of the information, the only argument that can be omitted is 
the “comment” argument.
NOTE
Up to 10 entries can be added to the SNMP Trap Host Table.
 
Syslog Parameters
The following parameters configure the Syslog settings.
Port Number
Octet String
User Defined
(there are also 4 
pre-defined protocols:
Index 1: NetBios Name 
Service – 137, Index 2: 
NetBios Datagram 
Service – 138, Index 3: 
NetBios Session 
Service – 139, Index 4: 
SNMP Service – 161)
RW
portnum
Protocol Name
DisplayString
User Defined
(there are also 4 
pre-defined protocols, 
see 
Port Number
 above)
RW
protoname
Interface Bitmask
Integer32
0 or 2 - no interfaces 
(disable)
1 or 3 - Ethernet
4 or 6 - Wireless A
8 or 10 - Wireless B
12 = Wireless A & B
13 or 15 - all interfaces 
(default is 15)
RW
ifbitmask
Status (optional)
Integer
enable (default for new 
entries)
disable (default for 
pre-defined entries)
delete
RW
status
Name
Type
Values
Access CLI Parameter
SNMP Trap Host Table
Table
N/A
R
snmptraphosttbl
Table Index
Integer
User Defined
N/A
index
IP Address
IpAddress
User Defined
RW
ipaddr
Password
DisplayString
User Defined (up to 64 
characters)
W
passwd
Comment (optional)
DisplayString
User Defined (up to 254 
characters)
RW
cmt
Status (optional)
Integer
enable (default)
disable
delete
RW
status
Name
Type
Values
Access
CLI
Syslog
Group
N/A
R
syslog
Syslog Status
Integer
enable
disable (default)
RW
syslogstatus
Syslog Port
Octet String
514
R
syslogport