Proxim AP-2000 Manuel D’Utilisation
178
Using the Command Line Interface (CLI)
Configuring a Security Profile with WPA-PSK Security Mode
set secprofiletbl <index> secmode wpa-psk passphrase <value> status enable
Example: set secprofiletbl 6 secmode wpa-psk passphrase 12345678 status enable
Example: set secprofiletbl 6 secmode wpa-psk passphrase 12345678 status enable
Configuring a Security Profile with 802.11i Security Mode
set secprofiletbl <index> secmode 802.11i rekeyint <value> status enable
Example: set secprofiletbl 7 secmode 802.11i rekeyint 900 status enable
Example: set secprofiletbl 7 secmode 802.11i rekeyint 900 status enable
Configuring a Security Profile with 802.11i-PSK Security Mode
set secprofiletbl <index> secmode 802.11i-psk passphrase <value> status enable
Example: set secprofiletbl 8 secmode 802.11i-psk passphrase 12345678 status enable
Example: set secprofiletbl 8 secmode 802.11i-psk passphrase 12345678 status enable
Other Parameters
IAPP Parameters
NOTE
These parameters configure the Inter Access Point Protocol (IAPP) for roaming. Leave these settings at their
default value unless a technical representative asks you to change them.
default value unless a technical representative asks you to change them.
SpectraLink VoIP Parameters (802.11b and bg Modes Only)
These parameters enable or disable the SpectraLink Voice over IP feature.
The Spectralink Legacy Support parameter should be enabled if the AP is operating in 802.11bg mode and legacy
802.11 Spectralink telephones are used. This parameter will set the basic rates of the AP to be 1 and 2 Mbps in
802.11bg mode and will allow old telephones that operate only at the 1 and 2 Mbps basic rate to connect to the AP.
The Spectralink Legacy Support parameter should be enabled if the AP is operating in 802.11bg mode and legacy
802.11 Spectralink telephones are used. This parameter will set the basic rates of the AP to be 1 and 2 Mbps in
802.11bg mode and will allow old telephones that operate only at the 1 and 2 Mbps basic rate to connect to the AP.
Name
Type
Values
Access
CLI Parameter
IAPP
Group
N/A
R
iapp
IAPP Status
Integer
enable (default)
disable
disable
RW
iappstatus
Periodic Announce
Interval (seconds)
Interval (seconds)
Integer
80
120 (default)
160
200
120 (default)
160
200
RW
iappannint
Announce Response
Time
Time
Integer
2 seconds
R
iappannresp
Handover Time-out
Integer
410 ms
512 ms (default)
614 ms
717 ms
819 ms
512 ms (default)
614 ms
717 ms
819 ms
RW
iapphandtout
Max. Handover
Retransmissions
Retransmissions
Integer
1 - 4 (default 4)
RW
iapphandretx
Send Announce
Request on Startup
Request on Startup
Integer
enable (default)
disable
disable
RW
iappannreqstart
Name
Type
Values
Access
CLI Parameter
Spectralink VoIP
Group
N/A
R
spectralink
Spectralink VoIP Status
Integer
enable
disable (default)
disable (default)
RW
speclinkstatus
Spectralink Legacy
Support
Support
Integer
enable
disable (default)
disable (default)
RW
speclinklegacysupport