RAD Data comm ASMi-52 Manuel D’Utilisation

Chapter 5  Configuring a Typical Application 

Installation and Operation Manual 

5-2 

Configuring the ASMi-52 units

 

ASMi-52 Ver. 2.5 

Two ASMi-52 units must be configured for this application. Both units have the 
same configuration parameters, except for the host IP address and the master clock 
mode. 

 

To prepare a control session: 
1.  Connect the terminal cable to the CONTROL connector of ASMi-52. 
2.  Turn the control terminal on. 
3.  Configure the terminal to the default communication parameters: 9.6 kbps, 

one start bit, eight data bits, no parity, one stop bit, VT100 emulation. 

4.  Select the full duplex mode. 
5.  Turn the terminal echo off. 
6.  Disable any type of flow control. 

You are now ready to start a control session. 

 

To enter the user name and password: 
1.  Type in your user name and press <Tab>. 

 

 

2.  Type in your password at the > prompt (up to eight characters). 

ASMi-52 responds to your entry with asterisks. 

3. Press <Enter>. 

The Main menu is displayed. 

 

To configure the master clock: 
1.  Display the Master Clock menu (Main menu > Configuration > System 

Configuration > Master Clock) 

The Master Clock menu appears. 

ASMi-52 

Master clock (Internal) 
1. Receive 
2. Internal 
3. External E1 
4. External V35 

> 

ESC-prev. menu; !-main menu; &-exit; @-scroll 

2.  From the Master Clock menu, four clock modes are given Receive, Internal, 

 or External V35.