RAD Data comm ASMi-52 Manuel D’Utilisation

Appendix B  IR-IP Interface Module 

Installation and Operation Manual 

B-16 

Advanced Setup 

ASMi-52 Ver. 2.5 

IR_IP 

 

<IR-IP> 

S/W Ver. 1.21 (date) 

Quick Setup 
Management Access 
Advanced Setup 

................................................................. 
 Device 

identification 

 Interface 

Parameters 

================================================================= 
 

1. LAN Status 

 

 

:[ Open  ] 

 

2. WAN Status 

 

 

:[ Open  ] 

 

3. WAN Throttle   

 

:[ Full  ] 

 

4. Aging Timeout (min)  :5. 

 
Press one of the numbers to select or ESC: 

2.  Set the LAN status to enable/disable the flow of packets through LAN interface: 

 

 – the flow of packets is enabled. 

 

 – the flow of packets is disabled. As a result, IR-IP does not accept, 

nor sends packets to the LAN, but its WAN interface may still be active, and 
can interact with other IP hosts on the WAN. 

3.  Set the WAN status to enable/disable the flow of packets through the WAN 

interface: 

 

 – the flow of packets is enabled. 

 

 – the flow of packets through the WAN interface is disabled. As a 

result, IR-IP does not accept from, nor sends packets to the WAN. 
However, the LAN interface of the IP router is still active. 

4.  Select the WAN Throttle. This is the maximum data rate at which frames are 

sent to the WAN (i.e., to the SHDSL link). 
The available selections are: 

 

64 kbps 

 

128 kbps 

 

256 kbps 

 

512 kbps 

 

1024 kbps 

 

Full (no restriction on the rate). 

Since the IP router buffers have a limited capacity (256 frames), it is 

recommended to select the WAN Throttle parameter in accordance with the 
line rate. 

5.  Specify the Aging Timeout. This is the time after which inactive LAN stations 

are removed from the IR-IP ARP table. 
A station is defined as inactive when no IP traffic is received from it by the 
IR-IP LAN interface.