RAD Data comm ASMi-52 Manuel D’Utilisation
Chapter 4 Configuration
Installation and Operation Manual
4-12
Configuring ASMi-52 System Parameters
ASMi-52 Ver. 2.5
2. If the autonegotiation is enabled, choose Max AutoNeg Capability from the
Local LAN Configuration menu.
The Set Capability menu appears.
3. Select the required LAN operation mode by choosing one of the following:
10BaseT half duplex
10BaseT full duplex
100BaseT half duplex
100BaseT full duplex.
4. If the autonegotiation is disabled, choose Default Type from the LAN
Configuration menu.
The Set Default menu appears.
5. Select the desired LAN operation mode by choosing one of the following:
10BaseT half duplex
10BaseT full duplex
100BaseT half duplex
100BaseT full duplex.
6. From the Local LAN Configuration menu, select Save.
Configuring Fault Indication
If ASMi-52 fault indication is enabled and a faulty condition or a loss of signal is
detected on the line, the Ethernet link is disconnected by ASMi-52. If fault
indication is not selected, fault conditions are not passed through to the LAN side.
detected on the line, the Ethernet link is disconnected by ASMi-52. If fault
indication is not selected, fault conditions are not passed through to the LAN side.
To set the fault indication:
1. From the Local LAN Configuration menu, select Fault Indication (Main menu
1. From the Local LAN Configuration menu, select Fault Indication (Main menu
> Configuration > LAN Configuration > Local LAN Configuration > Fault
Indication).
Indication).
Toggle between Yes and No.
2. Select Save to save your changes.
4.2
Configuring ASMi-52 System Parameters
This section describes the procedures for configuring system parameters of
ASMi-52.
ASMi-52.
To access the Configuration menu:
• From the Main menu, select Configuration.
• From the Main menu, select Configuration.
The Configuration menu appears (see
Figure 4-16
).