RAD Data comm ASMi-52 Manuel D’Utilisation

Installation and Operation Manual 

Chapter 4  Configuration 

ASMi-52 Ver. 2.5 

Configuring ASMi-52 System Parameters 

4-15 

The remote card mode configuration option is only available when ASMi-52 is 
connected to a remote unit.  When connected to a remote unit, each multiplexer 
unit can be configured to work as a single unit. For example, E1+Serial DTE, E1 
single, or Serial DTE single may be configured as an E1or IR (Serial DTE) unit. A 
multiplexer unit configured as a single unit does not behave as a multiplexer unit.  
The following applies in remote card mode configuration. 
•  IR (DTE Serial Interface) as a single unit 
•  E1 as a single unit 
•  E1 + IR as a multiplexer unit. 

 

To configure remote card mode: 
1.  From the Remote menu (Main menu > Configuration > System Configuration 

> Remote Card Mode), select the appropriate configuration by choosing E1, 
DTE

, LAN, E1 + LAN, E1 + V35, or V35 + LAN (see 

). 

The System Configuration menu returns. 

2.  From the System Configuration menu, select Save to save the changes 

ASMi-52 can be configured to work at a speed of 64/128 kbps (2-wire) and 
64/128/192/256 kbps (4-wire) when operating opposite devices with E1 DTE 
interface. The maximum data rate of ASMi-52 working in low speed mode is 
2048 kbps. 

 

To enable the low speed operation: 
1.  From the System Configuration, select Low Speed Operation (Main menu > 

Configuration > System Configuration > Low Speed Operation). 

The option value changes to Enable or Disable. 

2.  From the System Configuration, select Save to save the change. 
3.  Reset the ASMi-52. 

On start up the unit will operate in low speed mode.