RAD Data comm MBE10-8D Manuel D’Utilisation
MBE Family Installation and Operation Manual
Chapter 3 Operation
Operating Instructions
3-3
Power-on
To power-up MBE:
1. Set the POWER switch on the rear panel to the ON position.
1. Set the POWER switch on the rear panel to the ON position.
The POWER indicator lights up, indicating that MBE is powered on. After
about 1 minute, the operational status screen appears on the terminal
screen.
about 1 minute, the operational status screen appears on the terminal
screen.
2. Press the <Enter> key several times to display the password prompt.
Operating MBE
To operate MBE:
1. Configure MBE according to the application (see the
1. Configure MBE according to the application (see the
LAN RANger Series
Configuration Guide
).
2. During normal operation (when the remote workstations are active):
The READY indicator lights up continuously
The Tx and Rx indicators blink occasionally
The LAN and LINK error indicators remain OFF.
Power-off
To power-off MBE:
• Set the POWER switch on the rear panel to the OFF position.
• Set the POWER switch on the rear panel to the OFF position.
Order from: Cutter Networks
Ph:727-398-5252/Fax:727-397-9610
www.bestdatasource.com