Buffalo Technology WBMR-G54 Manuel D’Utilisation
WBMR-G54 Wireless ADSL Router User Guide
Bridge Filters
Bridge filters are used to block or allow various types of packets through the WAN interface. This may be done for
security or to improve network efficiency. The rules are configured for individual devices based on MAC address. Filter
rules can be set up for source, destination or both. You can set up filter rules and disable the entire set of rules without
loosing the rules that have been configured.
security or to improve network efficiency. The rules are configured for individual devices based on MAC address. Filter
rules can be set up for source, destination or both. You can set up filter rules and disable the entire set of rules without
loosing the rules that have been configured.
Bridge Filters window
To add a bridge filter rule, check Enable Bridge Filters, type in a Source MAC, a Destination MAC or both in the
entry fields, you may opt to limit filtering to only the Ethernet, and click the Apply button. To remove a bridge filter
from the table in the bottom half of the window, click the corresponding trashcan icon. Remember to save the
configuration changes.
entry fields, you may opt to limit filtering to only the Ethernet, and click the Apply button. To remove a bridge filter
from the table in the bottom half of the window, click the corresponding trashcan icon. Remember to save the
configuration changes.
The protocols that may be specifically allowed or denied to pass through the WAN interface are the following: IPv4,
IPv6, RARP, PPPoE Discovery and PPPoE Session.
IPv6, RARP, PPPoE Discovery and PPPoE Session.
66