Behringer ADA8200 Manuel D’Utilisation

ULTRAGAIN DIGITAL ADA8200

Quick Start Guide

(EN) 

(1) (2) (3)

(10)

(12)

(13)

(14)

(11)

(4)

(15)

(5)

(6) (7) (8)

(9)

(1) 

SIG LED indicates an input signal. This LED 

illuminates when an audio signal is present 

at one of the inputs.

(2) 

CLIP LED indicates the input signal level 

is too high. This LED illuminates when the 

audio signal peaks in the channel. Adjust the 

gain knob to reduce the signal level and 

avoid clipping.

(3) 

MIC IN connects XLR microphone 

or instrument input to Midas 

designed preamplifiers.

(4) 

GAIN knob adjusts the channel input level. 

The gain knob adjusts the input level for 

either the MIC IN or LINE IN connection.

(5) 

LINE IN connects 1/4" TRS input at line level.

(6) 

SYNC MASTER LED indicates that the 

ADA8200 is the master word clock source. 

External word clock devices receive their 

sync signal from the ADA8200.

(7) 

SYNC LOCKED LED illuminates when the 

ADA8200 is the master word clock source, 

or when receiving a valid sync signal from an 

external word clock source (via either ADAT 

or word clock in).

(8) 

PHANTOM POWER +48 V switches 

the +48 V phantom power on and off. 

Phantom power is active on all MIC IN inputs 

when engaged.

(9) 

ON/OFF POWER switch turns the ADA8200 

on and off.

(10) 

Power is supplied via an IEC cable connected 

to the mains. An IEC cable is provided.

(11) 

8-CHANNEL DIGITAL I/O ADAT OUT 

sends 8 channels of digital audio output 

from the analog inputs to an ADAT device. 

This output connects to other ADAT devices 

via TOSLINK cable.

(12) 

8-CHANNEL DIGITAL I/O ADAT IN sends 

8 channels of digital audio input from an 

ADAT device to the 8 analog line outputs. 

This input connects to other ADAT devices via 

TOSLINK cable.

(13) 

Word Clock Input connects to external 

devices for word clock synchronization. 

This BNC connector is only active when 

the SYNC selector (see 14) is switched to 

SLAVE > WC IN. All devices within the 

system (i.e. digital mixer, digital recorder, 

or computer recording interface) must be 

synchronized via a shared word clock signal.

(14) 

SYNC (Word clock settings selector) 

designates internal or external word clock 

configuration and sample rate. If the 

ADA8200 is slaved to an external word 

clock source, select either WC IN or ADAT IN 

according to your word clock connection. 

If the ADA8200 is functioning as the 

master word clock source for external ADAT 

devices, select the appropriate sample rate 

(either 44.1 or 48 kHz).

(15) 

LINE OUT XLR male connectors send 

D/A converted audio output from 

ADAT IN connector.