ZyXEL Communications NWA1100-N Manuel D’Utilisation
Chapter 12 Remote Management
NWA1100-N User’s Guide
115
12.7 The SNMP Screen
Use this screen to have a manager station administrate your NWA over the network. To change
your NWA’s SNMP settings, click REMOTE MGMT > SNMP. The following screen displays.
your NWA’s SNMP settings, click REMOTE MGMT > SNMP. The following screen displays.
Figure 57
Remote Management: SNMP
The following table describes the labels in this screen.
Table 40
Remote Management: SNMP
LABEL
DESCRIPTION
SNMP Configuration
Get Community
Enter the Get Community, which is the password for the incoming Get and
GetNext requests from the management station.
GetNext requests from the management station.
Set Community
Enter the Set community, which is the password for incoming Set requests
from the management station.
from the management station.
Trap Destination
Type the IP address of the station to send your SNMP traps to.
Trap Community
Type the trap community, which is the password sent with each trap to the
SNMP manager.
SNMP manager.
This field is available only when SNMPv1 or SNMPv2 is selected in the SNMP
Version field.
Version field.
Configure SNMPv3
User Profile
User Profile
Click this to go to the SNMPv3 User Profile screen, where you can configure
administration and user login details.
administration and user login details.
SNMP
Service Port
You may change the server port number for a service if needed, however you
must use the same port number in order to use that service for remote
management.
must use the same port number in order to use that service for remote
management.
Service Access
Select the interface(s) through which a computer may access the NWA using
this service.
this service.