ZyXEL Communications G-3000H Manuel D’Utilisation

G-3000H User’s Guide

166

Chapter 14 Maintenance

Find firmware at www.zyxel.com in a file that (usually) uses the system model name with a 
"*.bin" extension, e.g., "zyair.bin". The upload process uses HTTP (Hypertext Transfer 
Protocol) and may take up to two minutes. After a successful upload, the system will reboot.  
See the Firmware and Configuration File Maintenance chapter for upgrading firmware using 
FTP/TFTP commands.

Click MAINTENANCE and then F/W Upload. Follow the instructions in this screen to 
upload firmware to your ZyAIR. 

The following table describes the labels in this screen.

Note: Do not turn off the ZyAIR while firmware upload is in progress!

Network Mode

“Network mode” in this screen refers to your wireless LAN infrastructure (refer 

to the Wireless LAN chapter) and WEP setup. 
Network modes are: Infrastructure (same as an extended service set ESS)), 

Infrastructure with WEP (WEP encryption is enabled), Ad-Hoc (same as an 

independent basic service set IBSS)), or Ad-Hoc with WEP.

Refresh

Click Refresh to reload the screen. 

Table 56   Channel Usage

Table 57   Firmware Upload

File Path 

Type in the location of the file you want to upload in this field or click Browse ... 

to find it.

Browse... 

Click Browse... to find the .bin file you want to upload. Remember that you must 

decompress compressed (.zip) files before you can upload them. 

Upload 

Click Upload to begin the upload process. This process may take up to two 

minutes.