ZyXEL Communications 642R Series Manuel D’Utilisation
Prestige 642R Series ADSL Router
Remote Node Configuration
4-1
Chapter 4
Remote Node Configuration
In this chapter, we discuss the parameters that are protocol independent.
The protocol-dependent configurations are covered in subsequent chapters.
A remote node is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connection. Note that when you use Menu 4 to set up
Internet access, you are actually configuring one of the remote nodes.
gateway and the network behind it across a WAN connection. Note that when you use Menu 4 to set up
Internet access, you are actually configuring one of the remote nodes.
4.1 Remote Node Setup
This section describes the protocol-independent parameters for a remote node.
4.1.1 Remote Node Profile
To configure a remote node, follow these steps:
Step 1. From the Main Menu, select menu option 11 - Remote Node Setup.
Step 2. When Menu 11 appears, as shown in the following figure, enter the number of the remote node
Step 1. From the Main Menu, select menu option 11 - Remote Node Setup.
Step 2. When Menu 11 appears, as shown in the following figure, enter the number of the remote node
that you wish to configure.
Figure 4-1
Menu 11 - Remote Node Setup
Menu 11 - Remote Node Setup
1. ChangeMe (ISP,SUA)
2. ________
3. ________
4. ________
5. ________
6. ________
7. ________
8. ________
2. ________
3. ________
4. ________
5. ________
6. ________
7. ________
8. ________
Enter Node # to Edit: