ZyXEL Communications 650R-31/33 Manuel D’Utilisation
Prestige 650R-31/33 ADSL Router
4-6
Remote
Node
Configuration
4.2 Remote
Node
Setup
For the TCP/IP parameters, perform the following steps to edit Menu 11.3 – Remote Node Network
Layer Options as shown next.
Layer Options as shown next.
Step 1. In menu 11.1, make sure IP is among the protocols in the Route field.
Step 2. Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes, then press
[ENTER] to display Menu 11.3 – Remote Node Network Layer Options.
Figure 4-3 Remote Node Network Layer Options
The next table explains fields in Menu 11.3
–
Remote Node Network Layer Options.
Table 4-2 Remote Node Network Layer Options
FIELD DESCRIPTION
EXAMPLE
IP Address
Assignment
Assignment
Press [SPACE BAR] and then [ENTER] to select Dynamic if the
remote node is using a dynamically assigned IP address or Static if
it is using a static (fixed) IP address. You will only be able to
configure this in the ISP node (also the one you configure in menu
4), all other nodes are set to Static.
remote node is using a dynamically assigned IP address or Static if
it is using a static (fixed) IP address. You will only be able to
configure this in the ISP node (also the one you configure in menu
4), all other nodes are set to Static.
Dynamic
Rem IP Addr
This is the IP address you entered in the previous menu.
Rem Subnet Mask
Type the subnet mask assigned to the remote node.
Menu 11.3 - Remote Node Network Layer Options
IP Options: Bridge Options:
IP Address Assignment = Dynamic Ethernet Addr Timeout(min)= N/A
Rem IP Addr = 0.0.0.0
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= N/A
NAT= None
Address Mapping Set= N/A
Metric= 2
Private= No
Private= No
RIP Direction= None
Version= RIP-1
Multicast= None
IP Policies=
Enter here to CONFIRM or ESC to CANCEL: