ZyXEL Communications P-660HW-TX Manuel D’Utilisation
P-660HW-Tx v2 Series Support Notes
(3) Delete items from the auto-haunting preconfigured table by useing
command:
command:
wan atm vchunt remove <remote node> <vpi> <vci>
• Using Zero configuration.
You can enable/disable Zero Configuration in Network -> WAN -> Advanced
Setup:
Setup:
(1) After configure the auto-haunting preconfigured table. You just need a PC
connected to the device LAN Ethernet port with the DSL sync up.
(2) Open your web browser to access a Web site. It should prompt and request
for your username password of your ISP account, if your ISP provide PPPoE
or PPPoA service.
(3) After key-in the correct info, it will than test the connection. If it is
successful it will than close the browser and you can open a new browser to
surf the Internet. If the connection test fail, it will go back to the page ask for
user name and password.
connected to the device LAN Ethernet port with the DSL sync up.
(2) Open your web browser to access a Web site. It should prompt and request
for your username password of your ISP account, if your ISP provide PPPoE
or PPPoA service.
(3) After key-in the correct info, it will than test the connection. If it is
successful it will than close the browser and you can open a new browser to
surf the Internet. If the connection test fail, it will go back to the page ask for
user name and password.
82
All contents copyright © 2006 ZyXEL Communications Corporation.