Technicolor - Thomson 210i Manuel D’Utilisation
SpeedTouch 210i
64
Appendix A – Troubleshooting and FAQs
The following section explains how to use Telnet terminal commands to diagnose your
network problems via the built-in debug tool. Our examples use Windows Telnet client
software. If you are a Mac user, you should install third-party Telnet client software on
your computer. By default, the Linux has a built-in Telnet client.
network problems via the built-in debug tool. Our examples use Windows Telnet client
software. If you are a Mac user, you should install third-party Telnet client software on
your computer. By default, the Linux has a built-in Telnet client.
Using the Telnet Terminal Commands
Click Start
→
Run and type Telnet 10.0.0139 in the Open box as below. Note that
the IP address in the example is the default address of the Router. If you have changed the
default, enter the current IP address of the router.
default, enter the current IP address of the router.
Click OK. The Telnet terminal will open. If an administrator password has not been
assigned, follow the on-screen instructions to assign one.
After assigning a password, type a question mark (?). You will see all the possible Telnet
commands.
assigned, follow the on-screen instructions to assign one.
After assigning a password, type a question mark (?). You will see all the possible Telnet
commands.
10 .0. 0.13 9 10.0.0.139