AirLink PinPoint EDGE/GPRS Manuel D’Utilisation
PinPoint EDGE/GPRS - User Guide, version 2.32
63
AT Commands
FIGURE 8.
HyperTerminal: Connection Name
2.
Select COM1 (or the comport to which the modem is connected) for the Connect Using.
FIGURE 9.
HyperTerminal: Comport Setting
3.
Change the Bits per Second to 115200 (default), Data Bits to 8, Parity to None, Stop Bits to
1, and Flow Control to Hardware.
1, and Flow Control to Hardware.
FIGURE 10.
HyperTerminal: Comport Settings
4.
Type AT and press Enter. You should get a reply of “OK” or “0”. .
5.
To see what you are typing as you type it, you will need to turn on the echo and verbose mode.
Type ATE1V1 and press Enter.
Type ATE1V1 and press Enter.
If you get a reply of “OK”, then you entered the command successfully. If you get a reply of “0” or
“ERROR”, try entering the command again.
“ERROR”, try entering the command again.
Using AT Commands with a Terminal Application
•
The following pages list the AT commands, their parameters, and explain what they do. For
most commands, when you are entering them using a terminal connection, you will need to
preface the command with AT (exceptions are noted), i.e. ATA which listed as A
most commands, when you are entering them using a terminal connection, you will need to
preface the command with AT (exceptions are noted), i.e. ATA which listed as A
•
Some commands have specific parameters while other commands will take whatever you type.
•
Acceptable parameters and/or specific formats are in the parameters column.
Note:
If you have configured the PinPoint for settings different than the defaults for
Bits per Second, Data Bits, Parity, and/or Stop Bits, you will need to use your
changed settings.
changed settings.