AIS AI2524 Manuel D’Utilisation

Page de 418
AI2524 Router Card User’s Manual
Page 8-16
August 1997
2524UM
AI2524 RIP TCP/
IP Configuration
Routing Information Protocol (RIP) uses broadcast User Datagram 
Protocol (UDP) data packets to exchange routing information.
The Cisco IOS software sends routing information updates (advertise-
ments) every 30 seconds. If a router does not receive an update from 
another router for 180 seconds or more, it marks the routes served by 
the nonupdating router as being unusable. If there is still no update 
after 240 seconds, the router removes all routing table entries for the 
nonupdating router.
RIP sends updates to the interfaces in the specified networks. If an in-
terface's network is not specified, it will not be advertised in any RIP 
update.
RIP Configuration Task List
To configure RIP, complete the tasks outlined in the nest sections. You 
must enable RIP. The remaining tasks are optional.
z
Enable RIP
z
Allow Point-to-Point Updates for RI
z
z
z
z
z
Enable RIP
To enable RIP, perform these tasks, starting in global configuration 
mode:
1.
Enable a RIP routing process, which places you in router configu-
ration mode.
 router rip
2.
Associate a network with a RIP routing process.
 network 
network-number
Allow Point-to-Point Updates for RIP
RIP is normally a broadcast protocol. Therefore, for RIP routing up-
dates to reach point-to-point or nonbroadcast networks, you must con-
figure the Cisco IOS software to permit this exchange of routing