AIS AI2524 Manuel D’Utilisation

Page de 418
Chapter 9: AI2524 OSI/CLNP Configuration Steps
August 1997
Page 9-51
2524UM
Configure CLNS 
over WANs
This section provides general information about running ISO CLNS 
over WANs.
You can use CLNS routing on serial interfaces with HDLC, PPP, 
LAPB, X.25, Frame Relay, DDR, or SMDS encapsulation. To use 
HDLC encapsulation, you must have a router at both ends of the link. 
If you use X.25 encapsulation, and if IS-IS or ISO IGRP is not used on 
an interface, you must manually enter the NSAP-to-X.121 address 
mapping. The LAPB, SMDS, Frame Relay, and X.25 encapsulations 
interoperate with other vendors.
Both ISO IGRP and IS-IS can be configured over WANs.
X.25 is not a broadcast medium and, therefore, does not broadcast pro-
tocols (such as ES-IS) that automatically advertise and record map-
pings between NSAP/NET (protocol addresses) and SNPA (media 
addresses). (With X.25, the SNPAs are the X.25 network addresses, or 
the X.121 addresses. These are usually assigned by the X.25 network 
provider.) If you use static routing, you must configure the NSAP-to
X.121 address mapping with th
x25 map
 command.
Configuring a serial line to use CLNS over X.25 requires configuring 
the general X.25 information and the CLNS-specific information. 
First, configure the general X.25 information. Then, enter the CLNS 
static mapping information.
You can specify X.25 nondefault packet and window sizes, reverse 
charge information, and so on. The X.25 facilities information that can 
be specified is exactly the same as in the 
x25 map
 interface configu-
ration command.
Example: ISO CLNS over X.25 
In this example, serial interface 1 on Router A acts as a DTE for X.25. 
It permits broadcasts to pass through. Router B is an IS, which has 
CLNS address of 49.0001.bbbb.bbbb.bbbb.00 and an X.121 address of 
31102. Router A has a CLNS address of 49.0001.aaaa.aaaa.aaaa.00 
and an address of 31101. 
 illustrates this configuration.