AIS AI2524 Manuel D’Utilisation
Chapter 12: AI2524 X.25 Configuration Steps
August 1997
Page 12-53
2524UM
Note:
The
lapb hold-queue
command is no longer
supported, but the same functionality is provided by the
hold-queue
size out
standard queue control
command.
Configure Transparent Bridging over Multiprotocol LAPB
To configure transparent bridging over multiprotocol LAPB, perform
these tasks beginning in global configuration mode:
these tasks beginning in global configuration mode:
1.
Specify the serial interface, and enter interface configuration
mode.
mode.
interface serial
number
2.
Assign no IP address to the interface.
no ip address
3.
Configure multiprotocol LAPB encapsulation.
encapsulation lapb multi
4.
Assign the interface to a bridge group.
bridge-group
bridge-group
5.
Define the type of spanning tree protocol.
bridge bridge-group protocol {ieee|dec}
Note:
This feature requires use of the
encapsulation lapb
multi
command. You cannot use the
encapsulation
lapb protocol
command with a
bridge
keyword to
configure this feature.
Monitor and Maintain LAPB and X.25
To monitor and maintain X.25 and LAPB, perform any of these tasks
in EXEC mode:
in EXEC mode:
z
Clear all virtual circuits at once (everything—encapsulation, rout-
ed calls, and PAD calls—is cleared), or clear the single virtual cir-
cuit specified.
ed calls, and PAD calls—is cleared), or clear the single virtual cir-
cuit specified.
clear x25-vc
type number [lcn]
z
Display CMNS information.
show cmns [
type number ]
z
Display operation statistics for an interface.
show interfaces serial
number