AIS AI2524 Manuel D’Utilisation

Page de 418
Chapter 13: AI2524 Frame Relay Configuration Steps
August 1997
Page 13-5
2524UM
Configuration for Router 2
interface serial 0
ip address 131.108.64.1 255.255.255.0 
encapsulation frame-relay 
keepalive 10
frame-relay map ip 131.108.64.2 43
IPX Routing Example
This example illustrates how to send packets destined for IPX address 
200.0000.0c00.7b21 out on DLCI 102:
ipx routing 000.0c00.7b3b
!
interface ethernet 0 
ipx network 2abc
!
interface serial 0 
ipx network 200 
encapsulation frame-relay 
frame-relay map ipx 200.0000.0c00.7b21 102 broadcast
Configure the 
LMI
Local Management Interface (LMI) autosense enables the interface to 
determine the LMI type supported by the switch and eliminates the 
need to configure the Local Management Interface (LMI) explicitly.
Allow LMI Autosense to Operate
LMI autosense is active in these situations:
z
The router is powered up or the interface changes state to up.
z
The line protocol is down but the line is up.
z
The interface is a Frame Relay DTE.
z
The LMI type is not explicitly configured.
The LMI Autosense Process
When LMI autosense is active, it sends out a full status request, in all 
3 LMI options (ANSI, ITU, Cisco) to the switch.