AIS AI2524 Manuel D’Utilisation
Chapter 13: AI2524 Frame Relay Configuration Steps
August 1997
Page 13-25
2524UM
Point-to-Point Subinterfaces
In interface configuration mode, configure transparent bridging for
point-to-point subinterfaces:
point-to-point subinterfaces:
1.
Specify a serial interface.
interface serial
number
2.
Configure Frame Relay encapsulation on the serial interface.
encapsulation frame-relay
3.
Specify a subinterface.
interface serial
number.subinterface-number
point-to-point
4.
Associate a DLCI with the subinterface.
frame-relay interface-dlci
dlci [option]
5.
Associate the subinterface with a bridge group.
bridge-group
bridge-group
Example: Unnumbered IP over a Point-to-Point
Subinterface
Subinterface
This example sets up unnumbered IP over subinterfaces at both ends
of a point-to-point connection. In this example, Router A functions as
the DTE, and Router B functions as the DCE. Routers A and B are both
attached to Token Ring networks.
of a point-to-point connection. In this example, Router A functions as
the DTE, and Router B functions as the DCE. Routers A and B are both
attached to Token Ring networks.
Configuration for Router A
frame-relay switching
!
interface token-ring 0
ip address 131.108.177.1 255.255.255.0
!
interface serial 0
no ip address
encapsulation frame-relay IETF
!
interface Serial0.2 point-to-point
ip unnumbered TokenRing0
ip pim sparse-mode
frame-relay interface-dlci 20