AIS AI2524 Manuel D’Utilisation
AI2524 Router Card User’s Manual
Page 13-38
August 1997
2524UM
Disable or Reenable Frame Relay Inverse ARP
Frame Relay Inverse ARP is a method of building dynamic address
mappings in Frame Relay networks running IP and Novell IPX. In-
verse ARP allows the router or access server to discover the protocol
address of a device associated with the virtual circuit.
mappings in Frame Relay networks running IP and Novell IPX. In-
verse ARP allows the router or access server to discover the protocol
address of a device associated with the virtual circuit.
Inverse ARP creates dynamic address mappings, as contrasted with
the
the
frame-relay map
command, which defines static mappings
between a specific protocol address and a specific DLCI.
Inverse ARP is enabled by default but can be disabled explicitly for a
given protocol and DLCI pair. Disable or reenable Inverse ARP under
these conditions:
given protocol and DLCI pair. Disable or reenable Inverse ARP under
these conditions:
z
Disable Inverse ARP for a selected protocol and DLCI pair when
you know that the protocol is not supported on the other end of th
connection.
you know that the protocol is not supported on the other end of th
connection.
z
Reenable Inverse ARP for a protocol and DLCI pair if conditions
or equipment change and the protocol is then supported on the oth-
er end of the connection.
or equipment change and the protocol is then supported on the oth-
er end of the connection.
Note:
If you change from a point-to-point subinterface to a
multipoint subinterface, then change the subinterface
number. Frame Relay Inverse ARP will be on by default,
and no further action is required.
multipoint subinterface, then change the subinterface
number. Frame Relay Inverse ARP will be on by default,
and no further action is required.
You do not need to enable or disable Inverse ARP if you have a point-
to-point interface, because there is only a single destination and dis-
covery is not required.
to-point interface, because there is only a single destination and dis-
covery is not required.
To select Inverse ARP or disable it, perform one of these tasks in in-
terface configuration mode:
terface configuration mode:
z
Enable Frame Relay Inverse ARP for a specific protocol and
DLCI pair, only if it was previously disabled.
DLCI pair, only if it was previously disabled.
frame-relay inverse-arp
protocol dlci
z
Disable Frame Relay Inverse ARP for a specific protocol and
DLCI pair.
DLCI pair.
no frame relay inverse-arp
protocol dlci
Create a Broadcast Queue for an Interface
Very large Frame Relay networks might have performance problems
when many DLCIs terminate in a single router or access server that
must replicate routing updates and service advertising updates on each
DLCI. The updates can consume access-link bandwidth and cause sig-
nificant latency variations in user traffic; the updates can also consum
when many DLCIs terminate in a single router or access server that
must replicate routing updates and service advertising updates on each
DLCI. The updates can consume access-link bandwidth and cause sig-
nificant latency variations in user traffic; the updates can also consum