AIS AI2524 Manuel D’Utilisation

Page de 418
Chapter 16: Basic Configuration
August 1997
Page 16-5
2524UM
4.
Turn ON power to the router.
The router will load the operating system image from Flash mem-
ory. If the remote end of the WAN connection is connected and 
properly configured, the AutoInstall process will begin.
If AutoInstall successfully completes, you can write the configu-
ration data to the router's NVRAM.Perform this step to complete 
this task.
5.
Enter the 
copy running-config startup-config 
command:
Router# copy running-config startup-config
Taking this step saves the configuration settings that the AutoInstall 
process created in the router. If you do not do this, your configuration 
will be lost the next time you reload the router.
Using the System Configuration Dialog
If you do not plan to use AutoInstall, make sure all the WAN cables 
are disconnected from the router. This will prevent the router from at-
tempting to the run the AutoInstall process. The router will attempt to 
run AutoInstall whenever you power it on if there is a WAN   connec-
tion on both ends and the router does not have a configuration fil
stored in NVRAM. It can take several minutes for the router to deter-
mine that AutoInstall is not set up to a remote TCP/IP host.
If your router does not have a configuration (setup) file and you are not 
using AutoInstall, the router will automatically start the setup com
mand facility. An interactive dialog called the System Configuration 
Dialog appears on the console screen. This dialog helps you navigat
through the configuration process by prompting you for the configura-
tion information necessary for the router to operate.
Many prompts in the System Configuration Dialog include default an-
swers, which are included in square brackets following the question.