AIS AI2524 Manuel D’Utilisation

Page de 418
AI2524 Router Card User’s Manual
Page 16-12
August 1997
2524UM
3.
Configure the second synchronous serial interface, for example, 
as:
Configuring interface Seriall:
   Is this interface in use? [yes]:
   Configure IP on this interface? ~yes;:
   Configure IP unnumbered on this interface? [no]:
     IP address for this interface: 172.16.74.2
     Number of bits in subset field [8]:
     Class B network is 172.16.0.0, 8 subset bits; mask is
     255.255.255.0
Configure AppleTalk on this interface? [no]: yes
    AppleTalk starting cable range [3]: 5
    AppleTalk ending cable range [4]: 5
    AppleTalk zone name [myzone]: ZZ Serial
    AppleTalk additional zone name:
Configure IPX on this interface? [no]: yes
    IPX network number [3]: B003
4.
The configuration you enter is now displayed and you are asked if 
you want to use the displayed configuration. If you enter no, you 
will lose the configuration information you just entered and you 
can begin the configuration again. If you enter yes, the configura-
tion will be entered and saved in the startup configuration:
Use this configuration? [yes/no]: yes
Building configuration...
Use the enabled mode 'configure' command to modify this configuration.
    
    Press RETURN to get started!
Configuring 
ISDN
If you have an ISDN BRI WAN module, configure the BRI port for 
ISDN. This section explains typical ISDN configurations for one or 
two B channels. In the examples, the BRI port is configured for IP 
routing and Point-to-Point Protocol (PPP) encapsulation.
Complete these steps to configure the router for a basic ISDN PPP 
connection on a single B channel or two B channels, substituting th
correct address and host names as appropriate for your network.
1.
Enter enable mode:
Router> enable
Password: enable password