Klark Teknik DN 9650 Manuel D’Utilisation
Powering the unit
DN9650/DN9652 Network Bridge
Operator Manual
Operator Manual
3
Typical DN9652 audio connection configuration
Powering the unit
This section shows you how to connect the unit to the mains, switch the unit on/off and
electrically isolate the unit.
electrically isolate the unit.
The internal power supplies are of the switch mode type that automatically sense the
incoming mains voltage and will work where the nominal voltage is in the range
100VAC to 240VAC.
incoming mains voltage and will work where the nominal voltage is in the range
100VAC to 240VAC.
>> To switch the unit on/off
Making sure that the mains power at the power outlet is off, connect the mains cable
supplied with your DN965X to the mains power outlet and then to the mains socket at
the rear of your unit. To switch the unit on/off, use the mains on/off switch on the rear
of the unit. The blue KT roundel on the front of the unit will illuminate to show that
power is on.
supplied with your DN965X to the mains power outlet and then to the mains socket at
the rear of your unit. To switch the unit on/off, use the mains on/off switch on the rear
of the unit. The blue KT roundel on the front of the unit will illuminate to show that
power is on.
To electrically isolate the unit, switch it off and remove the mains cable from mains IEC
socket on the rear panel.
socket on the rear panel.
DN9652 rear panel
Video black burst source
Word clock target
Word clock source
Third party network
module
Network module A
Third party network
module
Network module B