Cisco Systems 5709 Manuel D’Utilisation
NetXtreme II
User Guide
January 2010
Bro a d c o m C o rp o r a ti o n
Page 228
Performing Diagnostics
Document
ENGSRVT52-CDUM100-R
P
ERFORMING
D
IAGNOSTICS
At the MS-DOS prompt, type uxdiag (for BCM5706/BCM5708/BCM5709 network adapters) or uediag (for BCM57710
network adapters) followed by the command options. The uxdiag command options are shown in
network adapters) followed by the command options. The uxdiag command options are shown in
and the uediag
. For example, to run all diagnostic tests on adapter #1 except Group B tests:
C:\>uxdiag -c 1 -t b
NOTE: You must include uxdiag or uediag at the beginning of the command string each time you type a command.
Table 1: uxdiag Command Options
Command Options
Description
uxdiag
Performs all tests on all Broadcom NetXtreme II adapters in your system.
uxdiag -c <devnum>
Specifies the adapter (devnum) to test. Use all in place of a specific device number to test
all adapters.
all adapters.
uxdiag -cof
Allows tests to continue after detecting a failure.
uxdiag -F
Forces an upgrade of the image without checking the version.
uxdiag -fbc <bc_image>
Specifies the bin file to update the bootcode.
uxdiag -fib <ib_image>
Specifies the bin file for iSCSI boot.
uxdiag -fibc
Programs the iSCSI configuration block. Used only with -fib <ib_image>.
uxdiag -fibp
Programs the iSCSI configuration software. Used only with -fib <ib_image>.
uxdiag -fipmi <ipmi_image>
Specifies the bin file to update IPMI firmware.
uxdiag -fmba <mba_image>
Specifies the bin file to update the MBA.
uxdiag -fncsi <ncsi_image>
Specifies the bin file to update the NCSI firmware.
uxdiag -fnvm <raw_image>
Programs the raw image into NVM.
uxdiag -fump <ump_image>
Specifies the bin file to update UMP firmware.
uxdiag -help
Displays the Broadcom NetXtreme II User Diagnostics (uxdiag) command options.
uxdiag -I <iteration num>
Specifies the number of iterations to run on the selected tests.
uxdiag -idmatch
Enables matching of VID, DID, SVID, and SSID from the image file with device IDs. Used
only with -fnvm <raw_image>.
only with -fnvm <raw_image>.
uxdiag -log <file>
Logs the test results to a specified log file.
uxdiag -mba <1/0>
Enables/disables Multiple Boot Agent (MBA) protocol.
1 = Enable
0 = Disable
uxdiag -mbap <n>
Sets the MBA boot protocol.
0 = PXE
1 = RPL
2 = BOOTP
3 = iSCSI_Boot