Cisco Systems 511 Manuel D’Utilisation
Chapter 4 Installing Hardware Options
Working with Hard Disk Drives
4-12
Cisco Content Engine 511 and 566 Hardware Installation Guide
OL-5756-01
Working with Hard Disk Drives
This section describes how to install a hard disk drive in the Content Engine. The
CE-511 requires a Serial Advanced Technology Attachment (SATA) hard disk
drive. CE-566 supports two 1-inch (2.54-cm) slim 3.5-inch (8.89-cm) LVD hard
disk drives. The CE-566 requires a SCSI hard disk drive.
CE-511 requires a Serial Advanced Technology Attachment (SATA) hard disk
drive. CE-566 supports two 1-inch (2.54-cm) slim 3.5-inch (8.89-cm) LVD hard
disk drives. The CE-566 requires a SCSI hard disk drive.
Installing a Hard Disk Drive in the CE-511
To install a simple-swap SATA hard disk drive in a bay, complete the following
steps.
steps.
Note
All hard disk drives being used in the Content Engine should have the same
throughput speed rating. Mixing hard disk drives with different speed ratings will
cause all hard disk drives to operate at the lower throughput speed.
throughput speed rating. Mixing hard disk drives with different speed ratings will
cause all hard disk drives to operate at the lower throughput speed.
Note
If your Content Engine has only one hard disk drive, install it in the left drive bay.
Caution
To maintain proper system cooling, do not operate the Content Engine for more
than 10 minutes without either a hard disk drive or a filler panel installed in
each bay.
than 10 minutes without either a hard disk drive or a filler panel installed in
each bay.
Step 1
Inspect the new drive for any signs of damage.
Step 2
Review the information in the
, and the
Step 3
Power down the Content Engine and peripheral devices, and disconnect the power
cord and all external cables.
cord and all external cables.
Step 4
.)