Canon SX80 MarK II Manuel D’Utilisation
55
Selecting an Input Signal (INPUT)
Proje
cti
ng
an
Im
Im
age
■Selecting an Input Signal
1
Press the INPUT button to pop up a window shown at the lower right.
The currently active input signal is marked with a circle and highlighted in orange.
An input signal that is ready for projection is displayed in white. When no signal is
received, it is displayed in gray.
In SX80 MarkII, [HDMI], [DIGITAL PC], and [ANALOG PC-1] may be displayed in
gray even if they are ready for projection.
An input signal that is ready for projection is displayed in white. When no signal is
received, it is displayed in gray.
In SX80 MarkII, [HDMI], [DIGITAL PC], and [ANALOG PC-1] may be displayed in
gray even if they are ready for projection.
2
The selection is toggled through available input signal types by pressing the INPUT
button.
button.
• You can select the target input signal with [ ] / [ ].
• Only the input signals displayed in white can be selected.
• Only the input signals displayed in white can be selected.
3
Press the OK button to determine the input signal type.
If no button is pressed in 4 seconds, the selected input signal type is chosen.
If no button is pressed in 4 seconds, the selected input signal type is chosen.
When you select [USB] with no PictBridge enabled equip-
ment or an USB flash memory connected and pressing the
OK button, a window waiting for you to connect a Pict-
Bridge enabled equipment or an USB flash memory
appears. For more details, refer to "Projecting an Image
from a Digital Camera (SX80 II)" (
ment or an USB flash memory connected and pressing the
OK button, a window waiting for you to connect a Pict-
Bridge enabled equipment or an USB flash memory
appears. For more details, refer to "Projecting an Image
from a Digital Camera (SX80 II)" (
).
Remote control
Top control
SX80 MarkII
SX800
<
<