Canon WUX450 Manuel D’Utilisation

157

Inst
alla
tio

n

 an
d Main

te

nan
ce

Inst
allation

Select [Width], and use the remote’s [ ] [ ] buttons to move the markers 
to the overlapping area.
The area between the starting and ending markers is called the blending area. 
Brightness of this area is automatically adjusted to match the brightness of 
other image areas. After you complete settings for the left image, do the same 
thing for the right image, to specify the blending area along the left edge. Adjust 
the area so that the blending area for the left and right images is the same.

Specifying a large blending area may cause dialog boxes for input signal selection or 
status to be covered by the blending area. In this case, momentarily switch edge blending 
from [Adjust] to [Off], check the display, and then return the setting to [Adjust].

Although the starting marker is normally aligned with the image edge, it can also be 
aligned more toward the center of the image. In this case, the black blending area will lie 
outside of the starting marker.

Example: When specifying the blending area for the 

lower-right image, configure the settings for 
blending areas along the top and left image 
edges.
Complete the settings for the other three 
images the same way for the edges that 
overlap.

Images from four projectors can also be blended, as 
shown at left.
Specify the blending area where each image overlaps 
with others.