Canon WUX450 Manuel D’Utilisation
221
Using the Projector in Direct Mode
Ne
two
rked
Mu
lti-Pr
two
rked
Mu
lti-Pr
ojection
O
p
er
at
ion
in
in
Ea
ch
ch
M
od
e
(7) IP address
To connect to projectors in another subnet, enter the projector’s IP address
here and click (8).
here and click (8).
(8) Find projectors
Find the projector with the IP address entered in (7). Results of projector
searching are shown in (9).
searching are shown in (9).
(9) Projector information
Indicates the name, installation location, and IP address of the projector
selected in the list or found after searching by IP address.
selected in the list or found after searching by IP address.
(10) Password
Passwords for projectors on which [NMPJ Password] on the projector’s
settings screen has been configured (
settings screen has been configured (
) must be entered here before
projection.
(11) Start
Start projection by the selected projector. During projection, this button is
labeled [Stop projecting] and can be clicked to stop projection.
labeled [Stop projecting] and can be clicked to stop projection.
(12) Switch primary/secondary monitor
A number is shown here only when secondary monitor connectivity is activated
on the computer. Clicking the number will switch between the primary and
secondary monitor.
on the computer. Clicking the number will switch between the primary and
secondary monitor.
(13) Blank the projector
Pause projection. Click again to resume projection.
(14) Settings
Display the settings window. (
(15) Projection status
Indicates the projection status.