Canon LV-8320 Manuel D’Utilisation

14

To ensure safe operation, please observe the following precautions :

  ● Use two (2) AAA type batteries.

  ● Always replace batteries in sets.

  ● Do not use a new battery with a used battery.

  ● Avoid contact with water or liquid.

  ● Do not expose the remote controller to moisture or heat.

  ● Do not drop the remote controller.

  ● If the battery has leaked on the remote controller, carefully wipe the case clean and install new   

     batteries.

  ● Risk of an explosion if battery is replaced by an incorrect type. 

  ● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.

Open the battery 

compartment lid.

Install new batteries 

into the compartment.

Replace the 

compartment lid.

For correct polarity 

(+ and –), be sure 

battery terminals are 

in contact with pins in 

compartment.

Point  the  remote  controller  toward  the  projector 

(Infrared  Remote  Receiver)  when  pressing  the 

buttons. Maximum operating range for the remote 

controller  is  about  16.4'(5  m)  and  60  degrees  in 

front of the projector.

16.4'

(5 m)

30° Remote controller

30°

The 2 different remote control codes (Code 

1–Code 2) are assigned to this projector. 

Switching the remote control codes prevents 

interference from other remote controllers when 

several projectors or video equipment next 

to each other are operated at the same time. 

Change the remote control code for the projector 

first before changing that for the remote controller. 

See "Remote control" in the Setting Menu on 

page 56.

Press and hold the MENU and IMAGE buttons 

for more than five seconds to switch between 

the 

Code 1 and Code 2. The initial code is set to 

Code 1.