Benq mw814st Manuel D’Utilisation
Maintenance
53
Replacing the lamp
•
To reduce the risk of electrical shock, always turn the projector off and disconnect the
power cord before changing the lamp.
power cord before changing the lamp.
•
To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes
before replacing the lamp.
before replacing the lamp.
•
To reduce the risk of injuries to fingers and damage to internal components, use caution
when removing lamp glass that has shattered into sharp pieces.
when removing lamp glass that has shattered into sharp pieces.
•
To reduce the risk of injuries to fingers and/or compromising image quality by touching
the lens, do not touch the empty lamp compartment when the lamp is removed.
the lens, do not touch the empty lamp compartment when the lamp is removed.
•
This lamp contains mercury. Consult your local hazardous waste regulations to dispose of
this lamp in a proper manner.
this lamp in a proper manner.
•
To assure optimal performance from the projector, it is recommended that you purchase a
qualified projector lamp for lamp replacement.
qualified projector lamp for lamp replacement.
•
If lamp replacement is performed while the projector is suspended upside-down from the
ceiling, make sure that no one is underneath the lamp socket to avoid any possible injury
or damage to the human eyes caused by fractured lamp.
ceiling, make sure that no one is underneath the lamp socket to avoid any possible injury
or damage to the human eyes caused by fractured lamp.
1.
Turn the power off and disconnect the projector from the power outlet. If the lamp is
hot, avoid burns by waiting for approximately 45 minutes until the lamp has cooled.
hot, avoid burns by waiting for approximately 45 minutes until the lamp has cooled.
2.
Loosen the screw that secures the lamp
cover on the side of the projector until the
lamp cover loosens.
cover on the side of the projector until the
lamp cover loosens.
3.
Remove the lamp cover from the
projector.
projector.
4.
Remove and dispose of the protection
film.
film.
•
Do not turn the power on with the lamp cover
removed.
removed.
•
Do not insert your fingers between the lamp
and the projector. The sharp edges inside the
projector may cause injuries.
and the projector. The sharp edges inside the
projector may cause injuries.
5.
Loosen the screw that secures the lamp.
6.
Lift the handle so that it stands up.
2
1
1
1
2