Benq MX766 Manuel D’Utilisation
Operation
29
Operation
Starting up the projector
1.
Plug the power cord into the projector and into
a power outlet. Check that the POWER
indicator light on the projector lights orange
after power has been applied.
a power outlet. Check that the POWER
indicator light on the projector lights orange
after power has been applied.
•
Please use the original accessories (e.g. power cable)
only with the device to avoid possible dangers such as
electric shock and fire.
only with the device to avoid possible dangers such as
electric shock and fire.
•
If Direct power on function is activated in the
SYSTEM SETUP: Basic > Operation Settings menu,
the projector will turn on automatically after the power cord has been connected and power
has been applied. See
SYSTEM SETUP: Basic > Operation Settings menu,
the projector will turn on automatically after the power cord has been connected and power
has been applied. See
"Direct Power On" on page 72
for details.
•
If Signal power on function is activated in the SYSTEM SETUP: Basic > Operation Settings
menu, the projector will turn on automatically when VGA signal is detected. See
menu, the projector will turn on automatically when VGA signal is detected. See
"Signal
Power On" on page 72
for details.
2.
Make sure the lens cover is open. If it is closed,
it could become deformed due to the heat
produced by the projection lamp.
it could become deformed due to the heat
produced by the projection lamp.
3.
Press
Power on the projector or ON on
the remote control to start the projector. The
POWER indicator light flashes and stays
green when the projector is on.
POWER indicator light flashes and stays
green when the projector is on.
The start up procedure takes about 10-20
seconds. In the later stage of start up, a startup
logo is projected.
(If necessary) Use the focus ring/focus slide lever
to adjust the image clearness.
seconds. In the later stage of start up, a startup
logo is projected.
(If necessary) Use the focus ring/focus slide lever
to adjust the image clearness.
If the projector is still hot from previous activity, it will run the cooling fan for approximately 90
seconds before energizing the lamp.
seconds before energizing the lamp.
4.
If the projector is activated for the first time,
select your OSD language following the on-
screen instructions.
select your OSD language following the on-
screen instructions.
5.
If you are prompted for a password, press the
arrow keys to enter a six digit password. See
arrow keys to enter a six digit password. See
"Utilizing the password function" on page 34
for details.
6.
Switch all of the connected equipment on.
7.
The projector will start to search for input
signals. The current input signal being scanned
displays in the screen. If the projector doesn't
signals. The current input signal being scanned
displays in the screen. If the projector doesn't
I
I