Benq PB2140 Manuel D’Utilisation
Operation
17
Operation
Start Up
1.
Switch all of the connected equipment on.
2.
Plug the power cord into the projector and into a wall socket.
3.
Turn on the wall socket switch (where fitted).
4.
Press and hold Power on the remote control or projector to start the unit. The Power
indicator light flashes green and stays green when the power is turned on.
indicator light flashes green and stays green when the power is turned on.
5.
The start up procedure takes about 30 seconds after pressing Power. In the later stage
of start up, a default BenQ logo appears.
of start up, a default BenQ logo appears.
6.
Then, the projector starts to search for input signals. Irrespective of selected input
source, the screen shows “Acquiring Signal” at the bottom right corner of the
screen. If there is no input source detected, one of three messages will be displayed on
the screen continuously: “Analog RGB Searching”, “Video Searching”, “S-Video
Searching”.
source, the screen shows “Acquiring Signal” at the bottom right corner of the
screen. If there is no input source detected, one of three messages will be displayed on
the screen continuously: “Analog RGB Searching”, “Video Searching”, “S-Video
Searching”.
7.
You can also press Source on the projector or remote control to select an input signal
to display if there are 2 or more devices are connected to the projector. For more infor-
mation, please refer to page
to display if there are 2 or more devices are connected to the projector. For more infor-
mation, please refer to page
If the frequency/ resolution of the input signal exceeds the projector’s operating range, you
will see the message “Out of Range” displayed on a blank screen.
will see the message “Out of Range” displayed on a blank screen.