Benq MX880UST Manuel D’Utilisation
Operation
50
Shutting down the projector
1.
Press
POWER on the projector or
OFF on the remote control, and a
confirmation message will display prompting you.
If you don't respond in a few seconds, the message will disappear.
2.
Press
POWER a second time. The POWER indicator light flashes orange, the
projection lamp shuts down, and the fans will continue to run for approximately 90
seconds to cool down the projector.
seconds to cool down the projector.
To protect the lamp, the projector will not respond to any commands during the cooling
process.
To shorten the cooling time, you can also activate the Quick cooling function. See
process.
To shorten the cooling time, you can also activate the Quick cooling function. See
for details.
3.
Once the cooling process finishes, a "Power Off Ring
Tone" will be heard. The POWER indicator light is a
steady orange and fans stop. Disconnect the power
cord from the power outlet.
Tone" will be heard. The POWER indicator light is a
steady orange and fans stop. Disconnect the power
cord from the power outlet.
•
To turn off the power ring tone, see
for details.
•
If the projector is not properly shut down, to protect the
lamp, when you attempt to re-start the projector, the fans
lamp, when you attempt to re-start the projector, the fans
will run for a few minutes to cool down. Press
POWER again to start the projector after the fans stop
and the POWER indicator light turns orange.
and the POWER indicator light turns orange.
•
Lamp life results will vary depending on environmental
conditions and usage.
conditions and usage.
Direct power off
The AC power cord can be pulled out right after the projector is turned off. To protect the
lamp, wait about 10 minutes before re-starting the projector. (When you attempt to re-start
the projector, the fans may run for a few minutes to cool down. In such cases, press
lamp, wait about 10 minutes before re-starting the projector. (When you attempt to re-start
the projector, the fans may run for a few minutes to cool down. In such cases, press
POWER again to start the projector after the fans stop and the POWER indicator light
turns orange.
I
I