Benq W6500 Manuel D’Utilisation

20 

Using the projector  

Eng
lish

Using the projector

Preparations
1. Plug in and turn all of the connected equipment on.
2. If not already in, plug the supplied power cable into the AC inlet 

on the rear of the projector. 

3. Plug the power cable into a wall power outlet and turn the wall 

switch on.

Turning the projector on

Follow the steps below.

1. Make sure the Power light is orange after power has been applied.
2. Press and hold POWER ON ( ) on the projector or remote control 

to turn the projector on.

3. The fans will start operating, and a start-up image displays on the 

screen for a few seconds while it warms up.

4. If you are prompted for a password, press the arrow keys to enter a six-digit password. See 

 for details.

5. "Source Searching..." will be displayed on the screen before the projector identifies the input source. 

This message will remain on the screen until a valid signal is detected. See 

 for details.

6. If the horizontal frequency of the input source exceeds the range of the projector, the message "No 

Signal" will be displayed on the screen. This message will remain on-screen until you change the input 
source to an appropriate one.