Sanyo PLC-XP200L Manuel D’Utilisation

Turn off the projector and unplug the AC power cord. Let 

the projector cool for at least 45 minutes.

Loosen the screw and open the lamp cover. Pull out the 

lamp by using the built in handle.

Replace the lamp with a new one. Make sure that the 

lamp is properly and fully inserted. 

Open the filter cover (p.62). 

Connect the AC power cord to the projector and turn on 

the projector.

Follow these steps to replace the lamp.

Reset the Lamp counter (p.65).

✔

For continued safety, replace with a lamp  of the 

same type. Do not drop the lamp or touch the 

glass bulb! The glass can shatter and may cause 

injury.

Allow a projector to cool for at least 45 minutes 

before you open the lamp cover. The inside of the 

projector can become very hot.

When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the 

screen and LAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing 

when the LAMP REPLACE indicator should light is depending on the lamp mode.

Lamp replacement icon

✔

Close the lamp cover and secure the screw. 

Lamp

Handle

Lamp cover

Filter cover

Screw

Close the filter cover.