Sanyo PLC-XP200L Manuel D’Utilisation

The WARNING indicators show the state of the function which protects the projector. Check the state of the 

WARNING indicators and the POWER indicator to take proper maintenance. 

When the temperature inside the projector reaches a 

certain level, the projector will be automatically shut down 

to protect the inside of the projector. The LAMP/SHUTTER 

indicator turns red and the WARNING TEMP indicator 

blinks while the projector is being cooled down. When the 

projector has cooled down enough (to its normal operating 

temperature), it can be turned on again by pressing the ON/

STAND-BY button.

✔

Then check the matters below:
–  Did you provide appropriate space for the projector to be 

ventilated? Check the installing condition to see if the air 

vents of the projector are not blocked.

–  Has the projector been installed near an Air-Conditioning/ 

Heating Duct or Vent? Move the installation of the 

projector away from the duct or vent.

–  Is the filter clean? Replace the filter with a new one.

When the projector detects an abnormal condition, it will 

be automatically shut down to protect the inside of the 

projector and the LAMP/SHUTTER indicator lights red and 

other four indicators blink. In this case, unplug the AC power 

cord and plug it, and then turn on the projector once again 

to verify operation. If the projector cannot be turned on and 

these indicators are still lighting and blinking, unplug the AC 

power cord and contact the service station.

DO NOT LEAVE THE PROJECTOR WITH THE 

AC POWER CORD CONNECTED UNDER AN 

ABNORMAL CONDITION. IT MAY RESULT IN FIRE 

OR ELECTRIC SHOCK.