Sanyo PLC-XP200L Manuel D’Utilisation

Serial Control Interface

Appendix

This projector provides a function to control and monitor the projector's operations by using the RS-232C serial

port.

Connect a RS-232C serial cross cable to CONTROL

PORT on the projector and serial port on the PC.

(See p.22)

Launch a communication software provided with PC

and setup the communication condition as follows:

Baud rate

: 9600 / 19200 bps

Parity check

: none

Stop bit

: 1

Flow control

: none

Data bit

: 8

Type the command for controlling the projector and

then enter the "Enter" key.
Example

When you want to change the input to INPUT 2, Type

'C' '0' '6' 'Enter'.

✔

Note:

• Enter with ASCII 64-byte capital characters and one-

byte characters.

✔

Note:

• The default of the baud rate is set to 19200 bps. If an

error occurs in the communication, change the serial

port and the communication speed (baud rate).

Operation