Sanyo WM5500L Manuel D’Utilisation

Before calling your dealer or service center for assistance, check the items below once again.

1.  Make sure you have properly connected the projector to peripheral equipment as described on pages 19-21.
2.  Check the cable connection. Make sure that all computers, video equipment, and power cords are properly connected.
3.  Make sure that all power is switched on.
4.  If the projector still does not produce an image, restart your computer.
5.  If an image still does not appear, disconnect the projector from your computer and check your computer monitor’s display. 

A problem may be noticed with your graphics controller rather than with the projector. (When you reconnect the projector, 
be sure to turn the computer and monitor off before you turn on the projector. Turn on equipment in the order of the 
projector and computer.)

6.  If a problem still persists, check the following solutions.

– Plug the power cord of the projector into the AC outlet.
–  Wait until the POWER indicator stops blinking to turn on the projector again. (See 

page 23)

–  Check the WARNING TEMP. indicator. If the WARNING TEMP. indicator is blinking, 

the projector cannot be turned on. (See page 72)

– Unlock the Key lock function for the projector.  (See page 61)
–  See if the filter cartridge is inserted.  (See page 67)
– Check the projection lamp.  (See page 70)

– PIN code lock is being set. Enter a PIN code; the “1234” or numbers

 PIN code lock is being set. Enter a PIN code; the “1234” or numbers you have set. 
(See pages 23, 61-62)

– Make sure Off or Countdown Off is not chosen at Display function.
   (See “Setting” section on page 52)

– Make sure User or Off is not chosen at Logo select function.
   (See “Setting” section on page 52)

– That is the Filter warning icon. (See page 66)

That is the Filter warning icon. (See page 66)

– That is the Lamp replacement icon or the Filter warning icon. (See pages 66,69)

That is the Lamp replacement icon or the Filter warning icon.  (See pages 66,69)

– Check the connection between your computer or video equipment and the projector.
–  See if the input signal is correctly output from your computer. Some laptop computers 

may need to be changed the setting for monitor output when connected to the 
projector. See your computer’s instruction manual for the setting.

– It takes about 30 seconds to display an image after turning on the projector.
– See if the selected system is corresponding with your computer or video equipment.
– Select correct input source once again through menu operation.  (See pages 33-35)
–  Make sure the temperature is not out of Operating Temperature

 (41˚F–104˚F [5˚C–

40˚C]).

 

–  End of lamp life is approaching. Replace the lamp with a new one promptly.  (See 

page 69)