Sanyo WM5500L Manuel D’Utilisation

  This cord is already fitted with a moulded plug incorporating a fuse, the value of which is indicated on the pin face of 

the  plug.  Should  the  fuse  need  to  be  replaced,  an ASTA  approved  BS  1362  fuse  must  be  used  of  the  same  rating, 
marked thus 

. If the fuse cover is detachable, never use the plug with the cover omitted. If a replacement fuse cover 

is required, ensure it is of the same colour as that visible on the pin face of the plug (i.e. red or orange). Fuse covers 
are available from the Parts Department indicated in your User Instructions.

  If the plug supplied is not suitable for your socket outlet, it should be cut off and destroyed.
  The end of the flexible cord should be suitably prepared and the correct plug fitted.  

 

The Wires in this mains lead are coloured in accordance with the following code:

   

Green-and-yellow ············· Earth

   

Blue ································· Neutral

   

Brown ······························ Live

  As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying 

the terminals in your plug proceed as follows:

  The wire which is coloured green-and-yellow must be connected to the terminal in the plug which is marked by the letter 

E or by the safety earth symbol 

 or coloured green or green-and-yellow.

  The wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black.
  The wire which is coloured brown must be connected to the terminal which is marked with the letter L or coloured red.

The AC Power Cord supplied with this projector meets the requirement for use in the country you purchased it.  

  AC  Power  Cord  used  in  the  United  States  and  Canada  is  listed  by  the  Underwriters 

Laboratories (UL) and certified by the Canadian Standard Association (CSA).

  AC Power Cord has a grounding-type AC line plug.  This is a safety feature to be sure that the 

plug will fit into the power outlet. Do not try to defeat this safety feature. Should you be unable 
to insert the plug into the outlet, contact your electrician.

GROUND

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 
15  of  the  FCC  Rules.  These  limits  are  designed  to  provide  reasonable  protection  against  harmful  interference  in  a 
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and 
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to 
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try 
to correct the interference by one or more of the following measures:
  – Reorient or relocate the receiving antenna. 
  – Increase the separation between the equipment and receiver. 
  – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 
  – Consult the dealer or an experienced radio/TV technician for help.
Use of shielded cable is required to comply with class B limits in Subpart B of Part 15 of FCC Rules.
Do  not  make  any  changes  or  modifications  to  the  equipment  unless  otherwise  specified  in  the  instructions.  If  such 
changes or modifications should be made, you could be required to stop operation of the equipment.

Model Number  

: PLC-WM5500, PLC-WM5500L

Trade Name  

: Sanyo 

Responsible party  

: SANYO NORTH AMERICA CORPORATION 

Address  

: 21605 Plummer Street, Chatsworth, California 91311, U.S.A.

Telephone No.  

: (818)998-7322