Vidikron SERIES 1080p Manuel D’Utilisation
40
Vidikron Vision 70 Series Owner’s Operating Manual
PRE
L
IMINAR
Y
Adjusting the Geometry:
1.
Input an anamorphic cross-hatch test pattern to the projector.
2.
Loosen
the three Lens Rotation Set Screws (shown in Figure 3-17) on the lens adapter
ring just enough to allow it to rotate freely.
3.
Grasp the lens by the center ring and rotate the lens until the image is properly
anamorphic:
anamorphic:
4.
When the image geometry appears correct, tighten the three Lens
Rotation Set Screws to secure the lens in place. (When viewed from
the front, the rear opening on the anamorphic lens should appear as
a tall, narrow oval.)
Rotation Set Screws to secure the lens in place. (When viewed from
the front, the rear opening on the anamorphic lens should appear as
a tall, narrow oval.)
Focus: Finally, rotate the Focus Ring on the anamorphic lens
to fine-tune the optical focus.
to fine-tune the optical focus.
Wrong Position
Correct Position
F
O
C
U
S