Fisher PDG-DWT50KL Manuel D’Utilisation
6. Maintenance
97
•
e.
•
for more details.
Replacing Consumable Parts
During the course of normal usage, consumable parts become worn out resulting in reduced performance. The following
guides detail how to replace the various consumable parts within the projector quickly and safely.
guides detail how to replace the various consumable parts within the projector quickly and safely.
•
Before replacing any of the parts, please take note of the following:
•
Ensure that the projector is turned off and disconnected from the power supply.
•
Ensure that the projector is in a clean, stable position before replacing parts.
•
Allow at least one hour after shutdown for the projector to cool before attempting replacing any consumable parts.
Do not interchange Lamp 1 and Lamp 2 after the projector has been used onc
Doing so will not allow the projector to display the correct lamp usage hours.
Doing so will not allow the projector to display the correct lamp usage hours.
Replacing the Filters
When the lamps are replaced, the filters should also be replaced, not cleaned.
Refer to the following guide to replace the filters.
CAUTION
and or fingers while lifting the projector to replace the filters. Doing so
could injure your hand or fingers.
Do not drop the projector on your h
Note:
The filters on the side and the rear are located on the bottom.
The filters on the side and the rear are located on the bottom.
1.
Gently slide the filter covers in the di-
rection shown.
rection shown.