Epson 800P Fascicule
EPSON
®
PowerLite
®
600p/800p/810p
Quick Setup
Connect the power cord to your projector and plug the other end into a grounded outlet.
3
Connect the other end to your laptop’s video or monitor port.
1
Turn on the projector first. To do so, press the red Power button.
The power light flashes green as the projector warms up,
and the projection lamp comes on in about 30 seconds.
The power light flashes green as the projector warms up,
and the projection lamp comes on in about 30 seconds.
2
Turn on or restart your laptop. (Windows only: If you see a
New Hardware Wizard screen for a Plug and Play monitor, click Cancel.)
New Hardware Wizard screen for a Plug and Play monitor, click Cancel.)
Turn Over
Press the red Power button twice, then let the projector cool while the power
light flashes orange (about a minute). Once the light stops flashing and stays on,
it’s safe to unplug the projector.
light flashes orange (about a minute). Once the light stops flashing and stays on,
it’s safe to unplug the projector.
Never unplug the projector when the power light is green or flashing orange.
Locate everything
you’ll need
you’ll need
Plug in your projector
Turn on your equipment
Caution: Before unplugging the projector...
For most setups, you’ll need just these two cables:
You won’t need to install any software.
1
2
Make sure your projector and laptop are turned off.
Connect one end of the computer cable to the
Computer 2/Component Video port on the projector.
Computer 2/Component Video port on the projector.
Connect the projector
to your laptop
to your laptop
power cord
computer cable
Follow these instructions to connect the projector
to your laptop. To connect other devices, such as
a VCR or desktop PC, see your User’s Guide.
to your laptop. To connect other devices, such as
a VCR or desktop PC, see your User’s Guide.
power button
power light