EIKI LC-WB40N Manuel D’Utilisation

To insure safe operation, please observe the following precautions :

 ●

 Use two (2) AAA or LR03 type alkaline batteries.

 ●

 Always replace batteries in sets.

 ●

 Do not use a new battery with a used battery.

 ●

 Avoid contact with water or liquid.

 ●

 Do not expose the remote control to moisture or heat.

 ●

 Do not drop the remote control.

 ●

 If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.

 ●

 Risk of an explosion if battery is replaced by an incorrect type. 

 ●

 Dispose of used batteries according to the instructions.

Press the lid 

downward and slide it.

Open the battery 

compartment lid.

Install new batteries 

into the compartment.

Replace the 

compartment lid.

For correct polarity 

(+ and –), be sure 

battery terminals are 

in contact with pins in 

compartment.

Point the remote control toward the projector (Infrared 

Remote Receiver) when pressing the buttons. Maximum 

operating range for the remote control is about 16.4'（5 m） 

and 60 degrees in front of the projector.

Projection angle can be adjusted up to 8.9 degrees with the 

adjustable feet. 

Lift the front of the projector and pull the feet lock latches on 

both side of the projector upward.

Release the feet lock latches to lock the adjustable feet and 

rotate the adjustable feet to a proper height, and tilt.

Keystone distortion can be adjusted automatically with the 

Auto setup function or manually by using the remote control 

or the menu operation (see pages 26, 47-48).

Adjustable Feet

Feet Lock Latches

16.4'

(5 m)

Remote control

30°

30°