EIKI LC-WB40N Manuel D’Utilisation

The preparation display will disappear 

after 30 seconds.

(See page 51 for Lamp control status.)

Lamp control status

Connect the projector’s AC power cord into an AC 

outlet. The POWER indicator lights red. Open the lens 

cover with the Slide Shutter. (see pages 10,64).
Press the POWER ON/SYAND-BY button on the top 

control or  on the remote control. The POWER indicator 

lights green and the cooling fans start to operate. The 

preparation display appears on the screen and the count 

down starts. 

After the countdown, the input source that was selected 

the last time and the lamp control status icon (see page 

53) appear on the screen.

If the projector is locked with a PIN code, PIN code 

input dialog box will appear. Enter the PIN code as 

instructed below.

Complete peripheral connections (with a computer, 

VCR, etc.) before turning on the projector.  

PIN (Personal Identification Number) code is a security 

code that allows the person who knows it to operate the 

projector. Setting a PIN code prevents unauthorized use of 

the projector.

A PIN code consists of a four-digit number. Refer to the PIN 

code lock function in the Setting Menu on pages 54–55 for 

locking operation of the projector with your PIN code.

Use the Point 

ed

 buttons to enter a number. Press the Point 

8

 button to fix the number and move the red frame pointer 

to the next box. The number changes to “✳.” If you fixed an 

incorrect number, use the Point 

7

 button to move the pointer 

to the number you want to correct, and then enter the correct 

number.

Repeat this step to complete entering a four-digit number.

After entering the four-digit number, move the pointer to “Set.” 

Press the SELECT button so that you can start to operate the 

projector.

If you entered an incorrect PIN code, “PIN code” and the 

number (✳✳✳✳) will turn red for a moment. Enter the correct 

PIN code all over again.

If you forget your PIN code, the projector can no 

longer be started. Take a special care in setting 

a new PIN code; write down the number in a 

column on page 80 of this manual and keep 

it at hand. Should the PIN code be missing or 

forgotten, consult your dealer or service center.

After the OK icon disappears, 

you can operate the projector.  

✔

  • When the Logo select function is set to 

“Off,” the logo will not be shown on the 

screen (p.50).

  • When the “Countdown off” or “Off” is 

selected in the Display function, the 

countdown will not be shown on the 

screen (p.48).

  • During the countdown period, all 

operations are invalid.

  • If the correct PIN code number is not 

entered within three minutes after the 

PIN code dialog box appeared, the 

projector will be turned off automatically.

  • The “1234” is set as the initial PIN code 

at the factory.

  • When the Input Search function is set to 

“On2”, the input signal will be searched 

automatically (p.51) 

✔

  • The Filter warning and Lamp 

replacement icons may appear on the 

screen depending on the usage state of 

the projector.