EIKI LC-X2U Manuel D’Utilisation

This projector

adjustable to different types of computer display signals based on VGA, SVGA, XGA or SXGA

(See “COMPATIBLE COMPUTER SPECIFICATIONS” on the next page). If you set MODE SELECT to

“COMPUTER”, the projector will automatically process the incoming signal and project the proper image without

any special setting. Although this will work in most cases, you may be required to manually set the projector for

some computer signals. If the computer image is not reproduced properly, try the following procedure and switch

to the computer display mode that you want to use.

1. Connect the COMPUTER to the PROJECTOR and turn the projector on first.

2. Set MODE SELECT to “COMPUTER MODE (1 or 2)”. This shows the current display mode initially detected by

the projector in the system window. And “Current mode” display appears.

NOTE:1. If the projector cannot discriminate or detect the input signal from the computer, the “Go PC adj.” display

appears.

NOTE : 2. If no input signal from the computer, the “No signal” display appears.

NOTE: 3. If the incoming signal is digital, the “D-VGA”, “D-SVGA”, “D-XGA” or “D-SXGA” display appears.

3. Press the MENU BUTTON and the MAIN MENU DISPLAY dialog box will appear.

4. Press the POINT LEFT/RIGHT BUTTON(s) to select SYSTEM and press the SELECT (REAR CLICK)

BUTTON. Another

dialog box COMPUTER SYSTEM DISPLAY will appear.

- -

5. Press the POINT DOWN BUTTON and a red arrow will appear.

6. If you want to change the current display mode, move the arrow by pressing the POINT UP/DOWN BUTTON(s)

to select one of the modes.

7. Press the SELECT (REAR CLICK) BUTTON to change the display mode.

8. To quit the MENU, move the arrow to Quit and then press the SELECT (REAR CLICK) BUTTON.

PC ADJUSTMENT

This is a special function that may be used when a computer image

not reproduced properly. (See the pages

48 for more detail.)