Hitachi CP-X955E Manuel D’Utilisation

29

ON indicator

LAMP indicator

TEMP indicator

Indicator status

Lights orange

Blinks green

Lights green

Blinks orange

Lights red

Lights red

Lights red

Blinks red

Meaning

Standby mode

During warming up

During operation

During cooling down

Under the mode

Lamp cannot light

Temperature inside too high

Cooling fan accidented

Remedy

—————————————

—————————————

—————————————

—————————————

Under the method

Cool projector by power off for 20 minutes.

Correctly reinstall so as not to block ventilation holes.

Call a maintenance person.

The ON indicator, LAMP indicator and TEMP indicator will light or blink in the following cases.

When the LAMP indicator lights, turn the power off.  If the problem cannot be recovered, contact your dealer.

Check the following again before asking for service.
If the trouble cannot be recovered, consult your dealer.

P12

P8

P8, P9

P12, P16

P8, P27

P8, P27

P9

P8, P9

P8, P27

P15

P15

P15

P28

P12, P15

P29

P6, P29

Power cannot be turned
on.

Only picture is displayed
with no sound

Only sound is heard
without a picture

• The Main power is not turned on.

• The power cord is disconnected.

• The setting of the input source is not

correct.

• Wiring to the projector is not correct.

• Wiring to the projector is not correct.

• The volume is set to minimum.

• The unit enters the mute mode.

• Wiring to the projector is not correct.

• The brightness is set fully to the dark side.

The color and tint have been adjusted
incorrectly.

• The brightness and contrast has been

adjusted incorrectly.

• The lamp has not been adjusted.

Focus or H.PHASE is not matched.

Trouble with the lamp.

Inside the projector too hot.

No picture and sound

Color is weak and tint is
incorrect

Picture is dark

Picture is not clear

LAMP indicator lights red.

TEMP indicator lights red.

• Turn the MAIN POWER switch on.

• Insert the power cord into an AC socket.

• Set the correct input using the input select

button of the projector or the remote
control.

• Connect the cable correctly.

• Connect the cable correctly.

• Press the VOL button or press the MENU

button and adjust the volume.

• Press the MUTE button.

• Connect the cable correctly.

• Press the MENU button and select

BRIGHT and press the 

 button.

• Turn the lens cover lever down and lens

cover opens.

Adjust the color and tint correctly.

• Adjust the brightness and contrast

correctly.

• Replace the lamp with a new one.

Adjust the focus or H.PHASE.

Turn off the power and leave for 20 minutes ;
then turn the power on again.

• Do not block the venational holes.

• Clean the air filter.

• Use the projector under 35˚C

temperature.

A bright dot may be seen in the picture.  This is a phenomenon peculiar to the liquid crystal and is not a problem.

manuals search engine