Infocus ScreenPlay 5000 Manuel D’Utilisation
28
Settings menu
Audio
: allows adjustments to the volume and mute, and turns the projec-
tor’s startup Chime on and off.
Sources
: allows you to assign a particular input to a specific source key on
the remote. Also allows selection of a default Startup Source and enables or
disables Autosource and RGB Video.
disables Autosource and RGB Video.
Sources>Startup Source:
this determines which source the projector
checks first for active video during power-up.
Sources>Autosource:
When Autosource is not checked, the projector
defaults to the source selected in Startup Source. If no source is found, a
blank screen displays. When Autosource is checked, Startup Source deter-
mines which source the projector defaults to at power-up. If no signal is
present, the projector checks the sources in order until a source is found or
until power down.
blank screen displays. When Autosource is checked, Startup Source deter-
mines which source the projector defaults to at power-up. If no signal is
present, the projector checks the sources in order until a source is found or
until power down.
Sources>RGB Video:
check this box if you are using a DVD player with
RGB output.
System>Rear:
reverses the image so you can project from behind a translu-
cent screen.
Ceiling
: turns the image upside down for ceiling-mounted projection.
Auto Ceiling
: automatically senses when the projector is inverted and turns
the image upside down. This is On by default.
Auto Power
: When Auto Power is checked, the projector automatically
goes into the startup state after the projector is powered on. This allows con-
trol of ceiling mounted projectors with a wall power switch.
trol of ceiling mounted projectors with a wall power switch.
Display Messages
: displays status messages (such as “Searching” or
“Mute”) in the lower-left corner of the screen.
Power Save
: automatically turns the lamp off after no signals are detected
for 5 minutes. After 3 additional minutes with no signal, the projector pow-
ers down. If an active signal is received before the projector powers down,
the image will be displayed.
ers down. If an active signal is received before the projector powers down,
the image will be displayed.
Screen Trigger
: turns on the 12 volt DC output switch on the connector
panel.
Backlight
: allows you to turn off the backlighting on the keypad.
Audio
Sources
Startup
Source
Source
System menu
Screen Save